Dagu - 9g 2 kg.cm Micro Servo Motor. This Micro Servo is ideal for applications where small weight and size are a key factor. The servo uses standard PWM control signals and operates from 4.8V - 6V with a power consumption of <500mA.
This end mill has a 2 straight flutes. It works well for materials where the lifting affect of a spiral flute might cause unwanted results, like wood or things with thin laminates or veneers. Best for Cutting Corian, plastic, linoleum, wood, plywood, MDF
Design custom (PCB) circuit boards with these FR1 machinable blanks. These circuit board blanks are made by bonding a thin layer of 1 ounce of copper over one or both sides of the entire substrate. To etch a circuit design into the material, unwanted copper can be removed using a CNCmachine, leaving only traces.
Dagu - Micro Servo 8g 1.5kg.cm. This Micro Servo is ideal for Applications where Small Weight and Size are a key factor.
The Servo uses standard PWM control signals and operates from 4.8V - 6V with a power consumption of <500mA.
Designed to fit LMR's universal sensor bracket, this sensor works by shinning IR light onto an object and then tracking the reflected IR. This sensor does not work in bright daylight as sunlight has a lot of IR and blinds the sensor.The IR LEDs can be controlled by a digital output so that ambiant light as well as reflected light can be measured. Your microcontroller needs 4 analog inputs available to use this sensor.
Inventables Solid Carbide Single Flute Upcut End Mill 1/8. The spiral upcut bits pull chips from the cutting surface upwards, leaving a flat bottomed pocket. This provides accurate cuts without chatter in the plastic because the chips are being evacuated away from the cutting edges. This bit is not recommended for wood because it pulls the wood fibers causing tear out.