This end mill has a 2 straight flutes. It works well for materials where the lifting affect of a spiral flute might cause unwanted results, like wood or things with thin laminates or veneers. Best for Cutting Corian, plastic, linoleum, wood, plywood, MDF
Inventables Solid Carbide Single Flute Upcut End Mill 1/8. The spiral upcut bits pull chips from the cutting surface upwards, leaving a flat bottomed pocket. This provides accurate cuts without chatter in the plastic because the chips are being evacuated away from the cutting edges. This bit is not recommended for wood because it pulls the wood fibers causing tear out.
. These fishtail bits are great for fine detail and inlays. The upcut tip design creates a cleaner edge on the backside of the sheet when cutting through materials. The flute design works well with high speed spindles and high feedrates.
This set of 6 bits is great for general purpose wood and plastic cutting.Best for cutting Corian, plastic, linoleum, wood, plywood, MDF.This bit set will get you started on your first or next wood/plastic based prject.
6 bits great for cutting soft metals like aluminum. This set of 6 bits is great for general purpose soft metal cutting. Bits have a shank diameter of 1/8 inch. Up-cut bits expel the cut material upward and smooths the bottom of the cut pass. It pulls heat away from the bit, and is a good choice for plastics, metals, or other materials that are prone to melting or burning.