Controlling extra sensors with a Java Program

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
1 postPage 1 of 1
1 postPage 1 of 1

Controlling extra sensors with a Java Program

Post by cbhanukiran » Fri Mar 12, 2010 2:45 pm

Post by cbhanukiran
Fri Mar 12, 2010 2:45 pm

Hello everyone,

I recently bought a Robonova and am planning to do my project using it. Basically I would like to some of the sensors like Tilt sensor, IR, Accelerometer, Touch sensor, Light and Distance Sensors.

I want to know if I could write a Java program in PC and access all the sensor readings to control the robot. (and I would like to use Blue tooth module instead of Serial port to download all the codes).

Does that make any sense ? Is it feasible ? If YES, please let me know. If I get a green signal, then I would go ahead and "buy" the required sensors. Thank you for your time.

C Bhanu Kiran
Hello everyone,

I recently bought a Robonova and am planning to do my project using it. Basically I would like to some of the sensors like Tilt sensor, IR, Accelerometer, Touch sensor, Light and Distance Sensors.

I want to know if I could write a Java program in PC and access all the sensor readings to control the robot. (and I would like to use Blue tooth module instead of Serial port to download all the codes).

Does that make any sense ? Is it feasible ? If YES, please let me know. If I get a green signal, then I would go ahead and "buy" the required sensors. Thank you for your time.

C Bhanu Kiran
cbhanukiran offline
Robot Builder
Robot Builder
Posts: 23
Joined: Thu Feb 25, 2010 7:20 am

1 postPage 1 of 1
1 postPage 1 of 1