KHR1-HV SERVO CALIBRATING

KHR-1, KHR-2HV, KHR-3HV, ICS servos, RCB controllers and other Kondo products
1 postPage 1 of 1
1 postPage 1 of 1

KHR1-HV SERVO CALIBRATING

Post by RaymondB » Mon Aug 03, 2009 12:35 pm

Post by RaymondB
Mon Aug 03, 2009 12:35 pm

Hiya...

I am struggling now with calibrating the servos! -
I can move them no problem (via the software) and I seem to set them to "0" (or as directed) - what now confuses me: They all seem to be on "0" anyway - When I first start to calibrate them!

The manual says its very important to get this step right, but in my mind, all the servos were set on "0" before I started moving them around via the slide in the actual software.

I have a feeling that I am missing something here?


Raymond
Hiya...

I am struggling now with calibrating the servos! -
I can move them no problem (via the software) and I seem to set them to "0" (or as directed) - what now confuses me: They all seem to be on "0" anyway - When I first start to calibrate them!

The manual says its very important to get this step right, but in my mind, all the servos were set on "0" before I started moving them around via the slide in the actual software.

I have a feeling that I am missing something here?


Raymond
RaymondB offline
Robot Builder
Robot Builder
Posts: 8
Joined: Sun Aug 02, 2009 3:36 pm

1 postPage 1 of 1
1 postPage 1 of 1
cron