ICS cable

KHR-1, KHR-2HV, KHR-3HV, ICS servos, RCB controllers and other Kondo products
5 postsPage 1 of 1
5 postsPage 1 of 1

ICS cable

Post by FrittsLogic » Sun Jan 01, 2006 9:21 pm

Post by FrittsLogic
Sun Jan 01, 2006 9:21 pm

Is the ICS cable that comes with the KHR-1 for communication with the RCB-1 the same cable used by servo manager software and gyro manager software? Will it work to allow reversing one servo for use with the krg-2?
Is the ICS cable that comes with the KHR-1 for communication with the RCB-1 the same cable used by servo manager software and gyro manager software? Will it work to allow reversing one servo for use with the krg-2?
FrittsLogic offline
Newbie
Newbie
User avatar
Posts: 4
Joined: Wed Dec 14, 2005 1:00 am

Post by inaki » Mon Jan 02, 2006 1:38 pm

Post by inaki
Mon Jan 02, 2006 1:38 pm

Nope. :-( The ICS cable is an active cable that is intended to send digital signals to the servo, while the standard cable is a common RS232 cable.
The only 'active' part that comes in the standard cable is a resistor!
Nope. :-( The ICS cable is an active cable that is intended to send digital signals to the servo, while the standard cable is a common RS232 cable.
The only 'active' part that comes in the standard cable is a resistor!
inaki offline
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 233
Joined: Sun Mar 06, 2005 1:00 am
Location: EH

Post by Guest » Mon Jan 02, 2006 6:23 pm

Post by Guest
Mon Jan 02, 2006 6:23 pm

Thanks for the reply. I don't suppose there's any way to modify the cable to work?
Thanks for the reply. I don't suppose there's any way to modify the cable to work?
Guest offline

Post by Guest » Mon Jan 02, 2006 8:38 pm

Post by Guest
Mon Jan 02, 2006 8:38 pm

Might anyone post the schematics of the ICS cable ? I have tried to read and write Kondo servos using a microcontroller but I cannot figure out how signals work. I am able to set motor position but the special functions (reading data or setting parameters) do not work. Anyone has been able to crack the commands sent to Kondo servos other than the usual position settings ?
Might anyone post the schematics of the ICS cable ? I have tried to read and write Kondo servos using a microcontroller but I cannot figure out how signals work. I am able to set motor position but the special functions (reading data or setting parameters) do not work. Anyone has been able to crack the commands sent to Kondo servos other than the usual position settings ?
Guest offline

Post by Guest » Fri Jan 06, 2006 2:58 pm

Post by Guest
Fri Jan 06, 2006 2:58 pm

Guest offline


5 postsPage 1 of 1
5 postsPage 1 of 1
cron