Connect Parallax PINGs direct to Wild Thumper motor control?

Traditional mobile robotics is all about wheeled robots.
1 postPage 1 of 1
1 postPage 1 of 1

Connect Parallax PINGs direct to Wild Thumper motor control?

Post by Grumpybeard » Tue Apr 09, 2013 1:55 pm

Post by Grumpybeard
Tue Apr 09, 2013 1:55 pm

Hi,

While awaiting delivery of all my rover goodies from Robosavy I'm looking at possibility of connecting Parallax ping ultrasonic sensors.

Apologies but I'm unsure if the Parallax ping sensors can be connected directly to the wild thumper motor controller for both power and data (analog connection using 3 pin servo/sensor cable?).

If not I wonder whether they can be connected to the Phidget 1018 interface kit?

Many thanks in advance.
Hi,

While awaiting delivery of all my rover goodies from Robosavy I'm looking at possibility of connecting Parallax ping ultrasonic sensors.

Apologies but I'm unsure if the Parallax ping sensors can be connected directly to the wild thumper motor controller for both power and data (analog connection using 3 pin servo/sensor cable?).

If not I wonder whether they can be connected to the Phidget 1018 interface kit?

Many thanks in advance.
Grumpybeard offline
Newbie
Newbie
Posts: 6
Joined: Tue Apr 09, 2013 1:49 pm

1 postPage 1 of 1
1 postPage 1 of 1