programming rb-2000 with vs-rc003

RB1000, VS-H8PWM28V2 controller, DSR and RDS servos
2 postsPage 1 of 1
2 postsPage 1 of 1

programming rb-2000 with vs-rc003

Post by psycho_dude » Wed Apr 16, 2008 3:14 pm

Post by psycho_dude
Wed Apr 16, 2008 3:14 pm

Hi, i'm new in the forum.
As I wrote in the subject i'm trying write a piece of open software to communicate with the vstone robot rb2000.
At the moment I can open a connection with the robot and send and recieve data packets, the problem is that i can't interpret th packets the robot sends to me (and obviously i don't know what kind of information i'm sending).
I tried sniffing USB I/O packets using RobovieMaker and
I tried to disassemble RobovieMaker in order to analyze its code, but I'm not able to get the informations i'm looking for.
any ideas?

Thanks.

P.S. I can't change the board.
Hi, i'm new in the forum.
As I wrote in the subject i'm trying write a piece of open software to communicate with the vstone robot rb2000.
At the moment I can open a connection with the robot and send and recieve data packets, the problem is that i can't interpret th packets the robot sends to me (and obviously i don't know what kind of information i'm sending).
I tried sniffing USB I/O packets using RobovieMaker and
I tried to disassemble RobovieMaker in order to analyze its code, but I'm not able to get the informations i'm looking for.
any ideas?

Thanks.

P.S. I can't change the board.
psycho_dude offline
Newbie
Newbie
Posts: 2
Joined: Wed Apr 16, 2008 2:59 pm

Post by psycho_dude » Mon Apr 28, 2008 2:12 pm

Post by psycho_dude
Mon Apr 28, 2008 2:12 pm

eventually I solved the problem.
eventually I solved the problem.
psycho_dude offline
Newbie
Newbie
Posts: 2
Joined: Wed Apr 16, 2008 2:59 pm


2 postsPage 1 of 1
2 postsPage 1 of 1