Surfaces

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
1 postPage 1 of 1
1 postPage 1 of 1

Surfaces

Post by xSVxSHaDOwZ » Thu Jun 09, 2011 12:54 am

Post by xSVxSHaDOwZ
Thu Jun 09, 2011 12:54 am

Ok thanks for everyone. With my Robo I have he is completly stable and does not wiggle at all if you try to move him. But if he trys to walk he will 100% of the time fall on his face :evil: is this due to the typ of surface he is trying to run/walk on or is it the coding I am using? Cause if it is the coding I am not I do not know how to do the running/walking coding I can only do the very very basic codes like raise his hands or the push ups/ waving. So can anyone tell whats going on here and how to fix it please.
Thanks For Reading
CJ
Ok thanks for everyone. With my Robo I have he is completly stable and does not wiggle at all if you try to move him. But if he trys to walk he will 100% of the time fall on his face :evil: is this due to the typ of surface he is trying to run/walk on or is it the coding I am using? Cause if it is the coding I am not I do not know how to do the running/walking coding I can only do the very very basic codes like raise his hands or the push ups/ waving. So can anyone tell whats going on here and how to fix it please.
Thanks For Reading
CJ
xSVxSHaDOwZ offline
Savvy Roboteer
Savvy Roboteer
Posts: 34
Joined: Fri Mar 25, 2011 5:49 pm

1 postPage 1 of 1
1 postPage 1 of 1
cron