Displaying Gyro information on a LCD

Hitec robotics including ROBONOVA humanoid, HSR-8498HB servos, MR C-3024 Controllers and RoboBasic
3 postsPage 1 of 1
3 postsPage 1 of 1

Displaying Gyro information on a LCD

Post by Gort » Mon Sep 07, 2009 7:25 pm

Post by Gort
Mon Sep 07, 2009 7:25 pm

I know that there is a trick to this but I cannot remember what it is?[/i]
I know that there is a trick to this but I cannot remember what it is?[/i]
Gort offline
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 555
Joined: Wed May 31, 2006 1:00 am
Location: KC, MO, USA

lcd and gyros

Post by engineer » Mon Sep 07, 2009 8:54 pm

Post by engineer
Mon Sep 07, 2009 8:54 pm

gort try searching for it on the forums I got 2 pages of hits
gort try searching for it on the forums I got 2 pages of hits
engineer offline
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 129
Joined: Wed Aug 09, 2006 1:00 am
Location: northern california

Post by i-Bot » Wed Sep 09, 2009 12:07 pm

Post by i-Bot
Wed Sep 09, 2009 12:07 pm

To see the value from Gyros, you need to PEEK the memory locations &H530 and &H531 for Gyro 0 and 1 repectively.

The zero value should be 44 decimal and sensitvity adjusted down to at least avoid saturation.
To see the value from Gyros, you need to PEEK the memory locations &H530 and &H531 for Gyro 0 and 1 repectively.

The zero value should be 44 decimal and sensitvity adjusted down to at least avoid saturation.
i-Bot offline
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 1142
Joined: Wed May 17, 2006 1:00 am


3 postsPage 1 of 1
3 postsPage 1 of 1