KRG-2 Gyro Software Manual Translated

KHR-1, KHR-2HV, KHR-3HV, ICS servos, RCB controllers and other Kondo products
1 postPage 1 of 1
1 postPage 1 of 1

KRG-2 Gyro Software Manual Translated

Post by se7en » Tue Aug 02, 2005 2:25 pm

Post by se7en
Tue Aug 02, 2005 2:25 pm

My Japanese, friend of a friend, software manual translator has come through for us with a partial translation of the KRG-2 Software Manual. She only translated the definitions of the internal settings:

Reverse:
Reverses the direction that the gyro works. In KRG-2 one sensor can turn on gyro effect independently on 2 channels.
Depending on the structure of the robot, settings vary. With KHR-1 for example, when using in back and forth directions,
you need to reverse the motion directions for left and right channels.

Digital Filter:
Filters processing the signals are implemented to smooth out the control signals.
See this ON for regular use.

Limit:
This setting regulates excessive correction signals from gyro caused by sudden change in figure position.
For regular use use the default value 200.

Gain 1-3:
For KRG-2 you can use "characteristic change" to switch the settings.
Combining with RCB-1, you can create motions, switching the 3 gains while in motion, by using set 1-3.
Setting gains can be done using the volume on KRG-2.
The value of the gain settings on software will be used as a multiplier to the volume setting on KRG-2.
When the volume setting is extremely low, the gain settings have no meaning.
For regular use set this 5 and under.

:D
My Japanese, friend of a friend, software manual translator has come through for us with a partial translation of the KRG-2 Software Manual. She only translated the definitions of the internal settings:

Reverse:
Reverses the direction that the gyro works. In KRG-2 one sensor can turn on gyro effect independently on 2 channels.
Depending on the structure of the robot, settings vary. With KHR-1 for example, when using in back and forth directions,
you need to reverse the motion directions for left and right channels.

Digital Filter:
Filters processing the signals are implemented to smooth out the control signals.
See this ON for regular use.

Limit:
This setting regulates excessive correction signals from gyro caused by sudden change in figure position.
For regular use use the default value 200.

Gain 1-3:
For KRG-2 you can use "characteristic change" to switch the settings.
Combining with RCB-1, you can create motions, switching the 3 gains while in motion, by using set 1-3.
Setting gains can be done using the volume on KRG-2.
The value of the gain settings on software will be used as a multiplier to the volume setting on KRG-2.
When the volume setting is extremely low, the gain settings have no meaning.
For regular use set this 5 and under.

:D
se7en offline
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 53
Joined: Mon Jun 13, 2005 1:00 am

1 postPage 1 of 1
1 postPage 1 of 1
cron