H2H Analogue compare trouble

KHR-1, KHR-2HV, KHR-3HV, ICS servos, RCB controllers and other Kondo products
1 postPage 1 of 1
1 postPage 1 of 1

H2H Analogue compare trouble

Post by Ausrobo » Sun Mar 21, 2010 10:00 pm

Post by Ausrobo
Sun Mar 21, 2010 10:00 pm

Help!

I am having trouble with the analogue compare branching tool in H2H on an RCB4.
I have a proximity sensor connected to one of the analogue ports and am able to see the values in the motion editing screen in the compare tool (using sync). I have played with the values and can not get it to branch! It will only follow the 0 branch. I have tried <,>, and even =!, still no go.

Does anyone know any tricks to get this going?

Thanks
Help!

I am having trouble with the analogue compare branching tool in H2H on an RCB4.
I have a proximity sensor connected to one of the analogue ports and am able to see the values in the motion editing screen in the compare tool (using sync). I have played with the values and can not get it to branch! It will only follow the 0 branch. I have tried <,>, and even =!, still no go.

Does anyone know any tricks to get this going?

Thanks
Ausrobo offline
Savvy Roboteer
Savvy Roboteer
Posts: 35
Joined: Sun Sep 27, 2009 10:05 pm

1 postPage 1 of 1
1 postPage 1 of 1
cron