HeartToHeart 4 version 1.1.0 English Patch (OLD)

KHR-1, KHR-2HV, KHR-3HV, ICS servos, RCB controllers and other Kondo products
46 postsPage 4 of 41, 2, 3, 4
46 postsPage 4 of 41, 2, 3, 4

Post by ks_khr3 » Sat Jul 10, 2010 4:23 pm

Post by ks_khr3
Sat Jul 10, 2010 4:23 pm

Hi Chris, you're most welcome. Let me know if you need my help.

On the topic of metal horns, I bought a set of ten from RoboSpot and came home to replace some high stress areas at some point. When I took apart a joint and proceeded with the metal horn I realized and oversight on my part.

The plastic horns use self tapping screws. The metal horns use the other type (not sure what they are called). I think its the 2.4M but not sure off the top of my head. So moral of the story, unless you have sufficient spares of those "other" screws make sure to order them at the same time you order the metal horns.

Look forward to your emerging design. It will be exciting for sure. All the best.
Hi Chris, you're most welcome. Let me know if you need my help.

On the topic of metal horns, I bought a set of ten from RoboSpot and came home to replace some high stress areas at some point. When I took apart a joint and proceeded with the metal horn I realized and oversight on my part.

The plastic horns use self tapping screws. The metal horns use the other type (not sure what they are called). I think its the 2.4M but not sure off the top of my head. So moral of the story, unless you have sufficient spares of those "other" screws make sure to order them at the same time you order the metal horns.

Look forward to your emerging design. It will be exciting for sure. All the best.
ks_khr3 offline
Savvy Roboteer
Savvy Roboteer
Posts: 39
Joined: Sun Jun 20, 2010 12:09 pm

Previous
Previous
46 postsPage 4 of 41, 2, 3, 4
46 postsPage 4 of 41, 2, 3, 4
cron