KHR ICPS PC Interface via rs232 Com Port

KHR-1, KHR-2HV, KHR-3HV, ICS servos, RCB controllers and other Kondo products
1 postPage 1 of 1
1 postPage 1 of 1

KHR ICPS PC Interface via rs232 Com Port

Post by Raymond » Thu Apr 16, 2009 6:13 pm

Post by Raymond
Thu Apr 16, 2009 6:13 pm

Hi Gang,

I would like to connect my RCB-3 via a com port not the USB. I saw in previous posts that pins 5,4&2,3 equate to the three output pins. There is a resistor between 4 & 2. Can anyone kindly indicate if this solution is adequate and what ohm resistor is required. Secondly is there amore professional design or unit that I can be directed.

Cheers

Mark
Hi Gang,

I would like to connect my RCB-3 via a com port not the USB. I saw in previous posts that pins 5,4&2,3 equate to the three output pins. There is a resistor between 4 & 2. Can anyone kindly indicate if this solution is adequate and what ohm resistor is required. Secondly is there amore professional design or unit that I can be directed.

Cheers

Mark
Raymond offline
Savvy Roboteer
Savvy Roboteer
Posts: 80
Joined: Sat Apr 11, 2009 7:17 pm

1 postPage 1 of 1
1 postPage 1 of 1