KRC-3 to Low Speed Port

KHR-1, KHR-2HV, KHR-3HV, ICS servos, RCB controllers and other Kondo products
17 postsPage 2 of 21, 2
17 postsPage 2 of 21, 2

Post by Hotproceed2 » Fri Mar 13, 2009 11:25 am

Post by Hotproceed2
Fri Mar 13, 2009 11:25 am

Hi

It moves successive while you push the button as follows when you make a motion.
1. Open the DATADlg and change the number1 of Controller input.
2. Set the motion as follows the picture and change the number1 in “Set the number in comparing resistor” of SET1.
3. Set CMP1 to “Jump the cotton input equals the comparing resistor”.

Image
Image
Image
Hi

It moves successive while you push the button as follows when you make a motion.
1. Open the DATADlg and change the number1 of Controller input.
2. Set the motion as follows the picture and change the number1 in “Set the number in comparing resistor” of SET1.
3. Set CMP1 to “Jump the cotton input equals the comparing resistor”.

Image
Image
Image
Hotproceed2 offline
Newbie
Newbie
Posts: 1
Joined: Fri Mar 13, 2009 11:03 am

Post by Orac » Fri Mar 13, 2009 7:03 pm

Post by Orac
Fri Mar 13, 2009 7:03 pm

Thanks Nana, I'll have a go at that myself as well.
Thanks Nana, I'll have a go at that myself as well.
Orac offline
Savvy Roboteer
Savvy Roboteer
User avatar
Posts: 299
Joined: Wed Feb 21, 2007 12:46 am
Location: UK, Near Aylesbury

Previous
Previous
17 postsPage 2 of 21, 2
17 postsPage 2 of 21, 2
cron