DIY -- Power Protection feature

Based on DMP's Vortex processor / SoC this board is a full computer capable of running a standard Windows and Linux installation on the backpack of your robot.
1 postPage 1 of 1
1 postPage 1 of 1

DIY -- Power Protection feature

Post by roboard » Mon Aug 24, 2009 9:37 am

Post by roboard
Mon Aug 24, 2009 9:37 am

There is small tricky for RoBoard if you worry will inverse power input to burn RoBoard, can refer to below circuit (RED Circle, add D32 and D33) to add your own power protection for RB-100



Image
The D32 is 1N5822
The D33 is TVS SMCJ28CA


Image
There is small tricky for RoBoard if you worry will inverse power input to burn RoBoard, can refer to below circuit (RED Circle, add D32 and D33) to add your own power protection for RB-100



Image
The D32 is 1N5822
The D33 is TVS SMCJ28CA


Image
roboard offline
Savvy Roboteer
Savvy Roboteer
Posts: 302
Joined: Fri Jul 03, 2009 4:44 am

1 postPage 1 of 1
1 postPage 1 of 1
cron