STOC Calibration Issues

Anything that doesn't fit our other forums goes here.
1 postPage 1 of 1
1 postPage 1 of 1

STOC Calibration Issues

Post by llewellyn » Fri Jul 15, 2011 2:22 am

Post by llewellyn
Fri Jul 15, 2011 2:22 am

My colleague and I are attempting to use a Videre Design STOC Stereovision 30cm camera, but we're having some problems with the onboard processing. When using offboard processing we get good data, but the data we're getting back is worthless when we use the camera's onboard processing. It seems possible that our calibration parameters aren't being properly uploaded to the camera's onboard processor, but we can't confirm this.

Has anybody encountered a similar problem using Videre hardware? Their support hasn't been much help to us, so we're at something of a dead end unless we can find someone else out there who might have some useful experience with this hardware.
My colleague and I are attempting to use a Videre Design STOC Stereovision 30cm camera, but we're having some problems with the onboard processing. When using offboard processing we get good data, but the data we're getting back is worthless when we use the camera's onboard processing. It seems possible that our calibration parameters aren't being properly uploaded to the camera's onboard processor, but we can't confirm this.

Has anybody encountered a similar problem using Videre hardware? Their support hasn't been much help to us, so we're at something of a dead end unless we can find someone else out there who might have some useful experience with this hardware.
llewellyn offline
Newbie
Newbie
Posts: 1
Joined: Fri Jul 15, 2011 2:22 am

1 postPage 1 of 1
1 postPage 1 of 1
cron